Reverse bucket steam trap It is the use of condensed water and steam density difference principle of work, the internal structure is connected by the lever inverted bucket, to overcome the steam pressure switch inverted bucket trap inside is an inverted bucket for the level of sensitive parts, Down bucket hanging down. When the device is started, air and low temperature condensate appear in the pipe. At this time, the trap is fully open, and the air and low temperature condensate are quickly discharged, and the device quickly raises the temperature. When steam enters the inverted bucket, the inverted bucket produces upward buoyancy, and the inverted bucket connects the lever to drive the valve to close the valve. Inverted bucket has a small hole to open the air automatically, as part of the steam discharged from the hole, the other part of the steam condensate, inverted bucket loses its buoyancy to sink, inverted bucket connected to the valve lever to open the valve lever. When the steam into the inverted bucket again, the valve closed again, work cycle, intermittent drainage. Reverse bucket steam trap is a mechanical steam trap in one of the most solid steam trap, its advantages are: not afraid of water hammer, continuous row of non-condensable gases, good anti-fouling performance; maximum back pressure ≥ 80%, all Inner parts are made of stainless steel, wear-resistant, corrosion-resistant; spherical valve seat and the valve seat is line contact, sealing performance, long service life; intermittent drainage and continuous drainage, can row close to the saturation temperature of condensate, heating equipment to achieve Best work efficiency. The inverted bucket steam trap valve seat is under the protection of water seal, no live steam leakage, energy saving effect is good. Figure inverted bucket steam trap for petroleum, chemical, printing, paper, pharmaceutical and other industrial steam heating equipment and steam pipe network of steam drainage. The advantages of inverted bucket steam traps: 1, all the moving parts of the cavity are stainless steel, wear-resistant, corrosion-resistant. 2, because the steam can not reach the valve seat hole is sealed, so no loss of steam, energy efficient. 3, float upside down, will not be destroyed crushed, not afraid of water hammer, long life. 4, inverted barrel top with vent. Continuous row of air performance, will not form a cold sluggish and air blocking. 5, from the impact of back pressure, under high back pressure can work well. 6, reliable work, only two moving parts (free lever structure and inverted barrel), it will not produce jamming. 7, the valve seat and the valve at the top of the valve in the switch can make dirt through, have good self-cleaning performance, no dirt problems.
Hot-Dipped Galvanized Steel Corrugated,Galvanized Steel Corrugated,Steel Coil Corrugated
Prepainted Steel Coil/sheet/strip Roofing Sheet Co,Ltd , http://www.nssteelcoil.com