Houses that have been inhabited for years, or caused by the damage of our external forces, often see the phenomenon of damage on the wall. This is the easiest way to make up the putty , and then apply the paint, basically no damage to the wall. Generally speaking, we have two choices in the face of this situation. One is to use wall plaster and the other is to use putty powder. The most common one is putty powder, so today Xiaobian mainly tells everyone about make-up putty. What are the details, as well as the specific construction steps.
First, what is the stress on the putty?
1. When you are ready to paint the wall with latex paint, and the original brush on the wall is lime or paint, you must first remove the original wall and re-scrape the putty before painting.
2, for customers who buy colored latex paint, Xiao Bian reminds everyone to do a one-time redemption of latex paint water, in order to avoid color block color difference when painting, resulting in uncoordinated conditions.
3, the quality of the roller brush is also the key to consider the quality of the putty. Therefore, the roller brush must be good, such as the hair quality and the amount of hair need to be moderately uniform, after all, this directly affects the effect of the brush.
4. When painting, you should first brush the ceiling and then brush the wall.
5, when painting, be sure to brush the second time after the first pass, so as not to cause the brush to peel off the wall.
6, when painting, if it is necessary to brush the light effect 2 times, if you want to add a strong color, you need to brush 3 times.
Second, the specific construction steps of the putty
1. The process of making concrete putty putty is: base treatment - base repair - brushing alkali solution - coating binder (grape paste) - scraping white putty - repairing and polishing - putty to survive.
2, concrete floor, floor slab repair putty process: base treatment - base repair - brushing alkali aqueous solution - coating binder (slurry, spray glue) - scraping white putty - repair and polishing - putty survive .
3. The process of applying cement mortar and paper ash surface layer to make putty is as follows: base layer treatment - coating binder (grape paste) - scraping white putty - repairing and polishing - putty to survive.
Third, the wall cracking may be too much for your putty
The surface of the putty is too thick, or too much scraping at a time will cause the wall to crack, and it will fall off seriously. If necessary, you should scrape it a few more times. Each time it is thinner, the interval should be longer. But pay attention to the number of putty putty, and it is easy to fall off.
Fourth, the reference price of putty paste
1, Saint-Gobain putty paste 20 kg reference price: ¥ 63.00;
2, the point of putty cream reference price: ¥ 110.00;
3, Nippon paint water-resistant putty paste 20 kg reference price: ¥ 118.00.
Through the above we can see that the price difference of putty paste is still very large, so when we make up the putty, we should choose the putty to combine with the actual situation, the first consideration of the construction area, the second consideration of whether the wall is important, if the area Too big, while pursuing the use of the best putty, the cost is quite large. For more exciting home improvement information, please continue to pay attention to the decoration home network.
More related wonderful reading:
Steps for tempered wall surface repair putty Precautions for tempered wall surface repair putty
What is water-based repair putty? Water-based repair putty common sense introduction
TD Cloud Security Co.Ltd , https://www.cctvcameraexpert.com